Free shipping on orders over $99 (Some exclusions apply)
(805)541-9000 Mon-Fri 6:30am - 5pm PDT
We are operating normally and shipping "in stock" items same day.

Pump, Sta-rite 2hp, Hot Spring (w/o volute cover & clamp)

Item #: 31239-NO-VOLUTE-BYP

Pump, Sta-rite 2hp, Hot Spring (w/o volute cover & clamp)


Starite two horsepower single speed jet pump (minus the volute cover and stainless steel clamp) is the replacement for the pump used on the 1989-1993 Hot Spring Highlife.

This jet pump has been obsoleted from the factory since June 2011. We assemble this pump using all the wet end parts from Hot Spring factory but leaving off the volute cover and the stainless steel clamp and we use the same energy efficient rated motor that Starite used at that time. You can just attach this jet pump to your existing hard plumbed volute cover and re-use your existing stainless steel clamp. No need to re-plumb the suction side of your spa. We provide the large volute o-ring.

*Please note: The power cord used for this assembly is no longer available, you will need to use the power cord from your existing pump. Please call our technicians if you have any questions. 

This Sta-rite 2HP pump was used on the following spas:
Hot Spring Models
MODEL Serial Range YEAR
Highlife (220v) K-291001 to K-131202 1989-1993

Technical Specs: 11.5 amp/230 volt AC, 2 hp, 1 speed.

Check Country Compatibility

Check Country


Restocking Fee Policy: