Free shipping on orders over $99 (Some exclusions apply)
(805)541-9000 Mon-Fri 6:30am - 5pm PDT

Wet End Kit, Wavemaster 7000 (ver. 3) 1.65 hp Pump

Item #: 72994

Description-

What's Included: Volute, volute cover, volute o-ring, volute stainless steel screws, wear ring, impeller and the shaft seal.

Description: This is the complete "wet end" of the jet pump. Your Wavemaster 7000 (v. 3) jet pump is comprised of two main components: the electric motor and the "wet end". In some cases, this entire "wet end kit" is needed. Perfect remedy if your 'wet end" has cracked due to a severe freeze since neither of the two halves are available individually. If your existing impeller is any color other than black, then you'll need this "wet end kit" as well. Here's why. One of the two pump manufacturers, that made this pump for Hot Springs, went out of business taking with them molds for the slightly smaller in diameter impeller. The shaft seal is still available . The front and top of this "wet end kit " will attach to your existing compression fittings (aka pump union).

Note: Measure the diagonal distance of the bolt holes on your pump. If the diagonal measurement is not 5 1/8" (5.134") from the center to the center of each hole, please call us.

Note #2: All "wet end kits" come pre-assembled from the factory. To install this kit you'll disassemble it and re-assemble it one piece at a time onto your existing pump motor. Typical assembly time of this kit is two hours for the non-service tech.

Note #3: After connecting the pump unions (compression fittings) the pump may not align with the holes that anchor the pump to the floor of the equipment compartment. You may need to re-anchor using no longer than 1" lag bolts. When pre-drilling for those bolts, do not pre-drill more than 1/4" into the floor of the equipment compartment or you may drill into plumbing lines.

Note #4: Some models may require minor plumbing modifications to connect to the new wet end. Please call our technicians with any questions. 

Note #5: If your pump has vendor of "4081" on it, then this is the correct wet end.  If your pump has vendor number of "3536" on it, then use part number 77711.

If your pump has vendor number of "3861", WE DO NOT HAVE REPLACEMENT PARTS. Please order complete pump 71699.

*Vendor code can be found on the sticker on the pump motor, click here for an example. 


Watch Video

Check Serial Number Compatibility

Want it delivered Wednesday, October 23rd ?
Order it in the next 14 Hours and 34 Minutes ,
and choose "UPS Next Day Air" Shipping at checkout (US only)

Options

:
:

Related Items

Compression Fitting O-rings, for 2" Union (Qty of 2)

(Quantity of 2 o-rings) O-rings used on the pumps 2" compression fittings ( 71036 ) found on most Hot Spring, Tiger River, Limelight, Hot Spot and Solana spa models. Also used on the replacement "Wet End" pump kits and some heaters.

Price: $2.96


RECENTLY VIEWED