Wet End Kit, Wavemaster 9000/9200 2.5 hp Pump
Item #: 72996
What's Included: Volute, volute cover, volute o-ring, volute stainless steel screws, wear ring, impeller and the shaft seal.
Description: This is the complete "wet end" for the Wavemaster® 9000 & 9200, 2.5HP pump. This "wet end" will attach onto your existing motor.
This is the complete "wet end" of the jet pump. Your Wavemaster 9000 & 9200 (v.2), 2.5 HP jet pump is comprised of two main components: the electric motor and the "wet end". In some cases, this entire "wet end kit" is needed. Perfect remedy if your "wet end" has cracked since neither the volute (attaches to the motor) or the volute cover (front of the pump) are available individually from the manufacturer.
Note: All "wet end kits" come pre-assembled from the factory. To install this kit you'll disassemble it then re-assemble it one piece at a time onto your existing pump motor. Typical assembly time is two hours for the non-service tech.
Note #2: After connecting the pump unions (compression fittings) the pump may not align with the holes that anchor the pump to the floor of the equipment compartment. You may need to re-anchor using no longer than 1" lag bolts. When pre-drilling for those bolts, do not pre-drill more than 1/4" into the floor of the equipment compartment or you may drill into plumbing lines.
Check Serial Number Compatibility
Order it in the next 18 Hours and 11 Minutes ,
and choose "UPS Next Day Air" Shipping at checkout (US only)
Hide Thomas M.,
Hide Connie C.,
Hide Jim H.,
more ... Catherine D.,
Hide Michael D.,